1979 Ford F-150 Project truck

2wd, 400 (bored .030), C6, 9 inch rear. Around $5,000 in new parts. Runs good. Haven't driven it since I got it back together. Has a couple of leaks that I haven't had time to address. Brakes need fluid and have to be bled. Fuel tank selector is bypassed. Running off rear tank only at this time.

New: Parking brake cables, rear brakes, rear steel brake lines, front and rear brake hoses, front brakes, front bearings/seals, rear axle u bolts, u joints, carrier bearing, single exhaust, shocks, rear leaf springs, rear leaf spring shackles, one leaf spring mount, steering linkages, front axle pivot bushings, power steering lines, power steering pump, neutral safety switch, transmission fluid and filter, gas caps, filler hoses, rear fuel tank, fuel sender floats, fuel sender pig tails, fuel pick up filters in tanks, fuel filter at carb, fuel lines, fuel pump, belt, coolant hoses, radiator cap, radiator gone through at C&R Radiator, battery cables, all engine gaskets, water pump, spark plugs, freeze plugs, harmonic balancer, motor mounts, PCV, Comp Cams Kit #32-241-4 (cam, timing chain set, lifters, springs).

I'm probably forgetting some parts. Frame is coated with Por15.

Included, but not pictured: Nice bench seat from 1980's F-150, box of misc. parts and hardware. Some parts available at extra cost: Curt receiver hitch (new), C6 shift kit (new), extra set of wheels (factory spokes with trim rings/center caps).

Have title. $10,000 obo.

Texts are the best way to reach me.